Satco NUVO LIGHTING 65-071 Instructions D'installation Et D'entretien

INSTALLATION AND SERVICE INSTRUCTIONS
INSTALLATION:
1. Attach fixture to outdoor box cover.
2. With power off, connect the hot supply wire to the hot fixture wire. The common supply wire to the common fixture wire. These
connections should be done using wire nuts or other approved connectors. The bare copper wire coming from the fixture is the
ground wire and should be fastened to the junction box with grounding screw, per National Electric Code.
3. Attach the cover and fixture to the box, making sure that All wires are contained inside the box and that the cover is properly gasketed
to prevent entrance of moisture.
4. Aim fixture by loosing arm and bolt and positioning to desired location. Tighten bolt.
IMPORTANT:
This fixture is intended to be used for general lighting in a normal open-air ambient. Do not install in closed ceiling, dead air, sheltered, buried
or boxed-in locations. It is not intended to be used in potentially dangerous locations such as flammable or explosive atmospheres.
AIMING:
1. Rotate fixture in horizontal plane to desired area to be illuminated. Secured in position with locknut.
2. Set vertical aiming by loosening bolt. Aim fixture at desired angle and securely re-tighten bolt.
TROUBLE SHOOTING CHECKLIST: If the light does not work.
1. Check your power source.
2. Check electrical connections.
©Copyright 2015 Satco Products, Inc. 10/15
Model: 65-071
LED Square Flood Light
Satco Products, Inc.,
Brentwood, NY 11717