Satco NUVO S11874 Manuel D'installation

LED 4"& 6" SLIM FIT DOWNLIGHTS
REMOTE DRIVER, FLAT LENS
Models: S11874, S11875, S11876, S11877
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING: Risk of Fire or Electric Shock
• Disconnect power before installation or any maintenance of the fixture.
• To avoid damage, falling, electric shock or fire, do not modify the fixture
or replace accessories without confirming with the supplier first.
• Only authorized, qualified personnel should install this fixture and
should follow the owner's manual.
• Do not dismantle the fixture without the supplier's authorization.
• Do not touch the power supply when the fixture is operating.
• For use in environments where an accumulation of non-conductive
dust on the fixture may be expected.
• Suitable for indoor wet locations.
• As per UL STD 1598: The volume of a wiring compartment or junction box with
more then one conduit or cable entry shall be calculated using two 12AWG branch
circuit conductors entering, and two 12AWG branch circuit conductors leaving,
and two 12AW insulated grounding conductors.
IMPORTANT:
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation of the
product and the hazards involved.
Model Dimensions Shape
S11874 4 inches Round
S11875 6 inches Round
S11876 4 inches Square
S11877 6 inches Square
INSTALLATION
TOOLS REQUIRED: Hole saw, measuring tape and connector cables (as needed).
NOTE: Use extensions if necessary. Available connector cables are 6' (1.8m).
Connector cables are linkable.
1. Turn power OFF from the electrical panel before starting installation.
2. Cut a hole in the ceiling for the downlight in a suitable position. Refer to Hole Cut
Dimension chart (below).
3. Run the electrical wire from the switch (power supply wire) through the mounting hole.
Use NMD90 Romex or BX cable. See Figure A.
4. Open the Junction Box swing cover and remove the appropriate knockouts.
5. I nsert the power supply wire through the knockout and fasten with a cable connector
(not included).
6. Connect wires inside the Junction Box using the quick connect terminals. Connect
green ground with the green box wire. Connect the black and white power leads with
the matching black and white box wires. See Wiring Diagram.
7. Put all wires and connections back into the box and close the cover securely.
8. New Construction Applications: Junction Box shall be firmly secured to the studs,
joists or similar fixed structural units.
Remodel Applications: Do not require the Junction Box to be firmly secured to fixed
structural units. Remove the Junction Box tabs, then insert into ceiling.
9. Bend back the two torsion springs and slowly fit the fixture through the ceiling hole. The
torsion springs will pull the fixture into place. See Figures B & C.
10. Once installation is complete, turn power ON to confirm the fixture is working properly.
Hole Cut Dimensions:
4" fixture = ø 4 3/16" (106mm)
6" fixture = ø 6 3/16" (157mm)
© Copyright 2023 Satco Products, Inc. 4/23 v1.0
Watts Volts CCT
10W
2700K
3000K
12W
120V 3500K
10W
4000K
5000K
12W
WIRING DIAGRAM
Power supply
CRI Finish
90 Black
Fixture Includes:
1 LED Lamp
1 Junction Box
Quick connect
Black wires
terminals
White wires
Green wires
Cable to fixture
Satco Products, Inc.
Brentwood, NY 11717