Satco NUVO 65-615 Instructions Pour L'installation

LED LARGE FLOOD LIGHT
Models: 65-615, 65-616, 65-617, 65-618, 65-619R1, 65-620R1
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING:
• To reduce the risk of personal injury or property damage
from fire, electric shock, falling parts, cuts/abrasions, and
other hazards read all warnings and instructions included
with and on the fixture and all fixture labels.
• Commercial installation, service and maintenance of
luminaries should be performed by a qualified licensed
electrician. For the installation: If you are unsure about
the installation or maintenance of the luminaries, consult
a qualified licensed electrician and check your local
electrical code.
• Turn off electrical power at fuse or circuit breaker before
wiring fixture to the power supply.
• Turn off the power when you perform any maintenance.
• All connections should be capped with UL approved wire
connectors.
• Minimum size 18 AWG or 14 AWG for continuous runs.
• Risk of Burn. Disconnect power and allow fixture to cool
before handling.
• Verify that supply voltage is correct by comparing it with
the luminaire label information.
• Do not install in a hazardous atmosphere, except where
the ambient temperature does not exceed the rated
operating temperature of the fixture.
• Keep tightly closed when in operation.
• Can be used for outdoor installation.
TOOLS REQUIRED:
• Crescent Wrench, Wire Strippers and Wire Cutters
INSTALLATION: Knuckle Mount
STEP 1: Before starting ensure that the power is
disconnected.
STEP 2: Unpack fixture and ensure that there are no
damaged parts.
STEP 3: Attach fixture to outdoor box cover, routing the
fixture wires into the junction box. Connect fixture cables
as seen in wiring diagram. Black to Black, White to
White, and Green to Green.
Aim fixture by loosening bolt on the arm, and
repositioning to the desired angle. Tighten the bolt.
STEP 4: Wire end of cord to power supply as seen in
wiring diagram.
© Copyright 2023 Satco Products, Inc. 9/23 v5.0
70W: 65-615, 65-616
90W: 65-617, 65-618
with knuckle mount
ELECTRICAL REQUIREMENTS
• The LED driver must be suplied with 120-277V for
70W & 90W versions and 120-347V for 150W versions,
50/60 Hz and connected to an individual, properly
grounded branch circuit protected by a 20 ampere
circuit breaker. Use min. 90°C supply.
GROUNDING INSTRUCTIONS:
• The grounding and bonding of the overall system
shall be done in accordance with NEC Article 600
and local codes.
INSTALLATION: Slipfitter Mount
Follow STEPS 1 & 2 from Knuckle Mount installation
STEP 3: Separate the bracket and pass the input wire
of the fixture through the bracket.
STEP 4: Pass the input wire through the bracket and
lock the bracket.
STEP 5: Connect fixture cables as seen in wiring diagram.
STEP 6: Aim fixture by loosening bolt on the arm, and
repositioning to the desired angle. Tighten the bolt.
WIRING DIAGRAM
Black/Brown
Line
Green/Yellow
Fixture
Ground
White/Blue
Neutral
150W: 65-619R1, 65-620R1
with slipfitter mount
:
Satco Products, Inc.
Brentwood, NY 11717