EINHELL BT-SG 100 Mode D'emploi page 8

Anleitung_BT_SG_100_SPK1:_
GB
6. Operation
After each heating phase of max. 12 seconds,
the device must be switched off for at least 48
seconds. That means that the soldering gun may
only be used when it is switched off.
Ensure that the parts you wish to solder are
clean. Clean the parts beforehand with steel
wool or fine abrasive paper.
Ensure that the soldering gun is coated with tin.
If necessary coat it using the soldering wire
supplied. Never clean the soldering tip with a file.
Wipe down the soldering tip with a silicon sponge
and then coat the soldering tip with tin.
Heat the soldering point and not the solder.
Touch the parts you wish to solder with the
soldering tip so that both parts are heated
uniformly. Add a little tin solder to the soldering
point.
Move the soldering gun carefully and quickly
without moving the parts you wish to solder.
Do not use too much solder. Only use as much
tin solder as is absolutely necessary.
Electrical and electronic components must not be
overheated.
If you wish to solder wires together, the ends
should be coated with tin first. Twist the cores
together, heat them and add a little tin solder.
You can repair items made of thermoplastic
(childrenʼs toys) using the plastic tip.
The normal soldering tip can be used for fire art
on wood and leather.
7. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8
15.09.2008 17:27 Uhr Seite 8
8. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
9. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.