EINHELL BT-SG 100 Mode D'emploi page 7

Anleitung_BT_SG_100_SPK1:_
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the booklet included in delivery for the
safety instructions.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
Additional safety instructions
Only hold the heated soldering gun by the
handle. Risk of burns!
Only place the heated soldering gun on non-
flammable and heat-resistant surfaces. They
may catch fire.
The screw connection on the soldering gun must
be tight. Check this before you start work.
Always hold the mains cable away from the
soldering tip.
Do not glue up the ON/OFF button on the
soldering gun.
The workpiece should be adequately secured as
a result of the high working temperatures.
The soldering tip will become hot during use and
if it is not used correctly it may cause burn
marks, singeing and, in the worst case scenario,
burns and fires.
Do not dip the soldering gun into water and do
not hold the soldering tip under running water.
Wear safety goggles whilst soldering, tine and
flux spatter may cause eye injuries.
Some flux types develop unpleasant vapors
during heating. Ensure that there is adequate
ventilation at your workplace.
15.09.2008 17:27 Uhr Seite 7
2. Layout (Fig. 1)
1 ON/OFF switch
2 Soldering point light
3 Union nuts to secure the soldering tip
4 Soldering tip
3. Proper use
The soldering gun is to be used for minor soldering
work, electric solder joints, model-making and fire
art.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Mains voltage 230 V ~ 50 Hz
Power rating
Heating time
Down time
Light 0.25 A / 0.55 W
Totally insulated
Weight:
The declaration "S3 1 min. 20%" on the rating plate
means that the soldering gun may be switched on for
12 seconds and must then be switched off for 48
seconds since otherwise the soldering tip will
overheat and the soldering gun will be damaged.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
GB
100 W
12 seconds
48 seconds
II/
0.625 kg
7