Beko CN163222DX Manuel D'utilisation page 9

3 Installation
Always have the installation and repairing
procedures carried out by the Authorized Service
Agent. Manufacturer shall not be held liable for
damages that may arise from procedures carried
out by unauthorized persons.
Refer to the nearest Authorized Service Agent for
installation of the product. To make the product
ready for use, make sure that the electricity
installation is appropriate before calling the
Authorized Service Agent. If not, call a qualified
electrician to have any necessary arrangements
carried out.
C
Preparation of the location and electrical
installation at the place of installation is
under customer's responsibility.
B
Product must not be plugged in during
installation. Otherwise, there is the risk
of death or serious injury!
WARNING:
connections of the product must be
B
carried out by the Authorised Service
Agent. Manufacturer shall not be held
liable for damages that may arise from
procedures carried out by unauthorised
persons.
WARNING:
A
check if the product has any defects
on it. If so, do not have it installed.
Damaged products cause risks for your
safety.
C
Make sure that the power cable is not
pinched or crushed while pushing the
product into its place after installation or
cleaning procedures.
3.1. Appropriate installation location
WARNING:
A
the product will be placed is too small for
the product to pass, then the product's
doors must be removed and the product
must be turned aside to pass it through.
• Choose a place at where you would use the
product comfortably.
• Install the product at least 30 cm away from
heat sources such as hobs, ovens, heater
cores and stoves and at least 5 cm away from
electrical ovens. Product must not be subjected
Installation and electrical
Prior to installation, visually
If the door of the room where
to direct sun light and kept in humid places after
installation.
• Appropriate air ventilation must be provided
around your product in order to achieve an
efficient operation. If the product is to be placed in
a recess in the wall, pay attention to leave at least
5 cm distance with the ceiling and side walls.
• Do not place the product on the materials such as
rugs or carpets.
• Place the product on an even floor surface to
prevent jolts.
C If two coolers are to be installed side
by side, there should be at least 8 cm
distance between them. Otherwise,
adjacent side walls may get damp.
3.2. Installing the plastic wedges
Plastic wedges are used to create the distance for
the air circulation between the product and the
rear wall. Insert the 2 plastic wedges onto the rear
ventilation cover as illustrated in the figure. To install
the wedges, remove the screws on the product and
use the screws given in the same pouch with the
wedges.
3.3. Electrical connection
Connect the product to a grounded outlet
protected by a fuse complying with the values in
the rating plate. Our company shall not be liable
for any damages that will arise when the product
is used without grounding in accordance with the
local regulations.
8 /36EN
Refrigerator / User manual