Publicité
Les langues disponibles
Les langues disponibles
ANTI-TIP BLOCK
Figure 3
NORMAL INSTALLATION STEPS
ANTI-TIP BLOCK INSTALLATION INSTRUCTIONS
To reduce the risk of tipping over the drawer, the Anti-Tip block must be
properly installed and located 14 inches above the floor on which the
Microwave Drawer will sit. The 6-inch Anti-Tip block must be provided by the
installer. See Figures 1 and 3. The Anti-Tip block prevents serious injury that
might result from spilled hot liquids. If the Microwave Drawer is ever moved
to a different location, the Anti-Tip block must also be moved and installed,
when installed to the wall make sure that the screws completely penetrate
the drywall and are secured in wood or metal so that the block is stable.
When fastening, be sure that the screws do not penetrate any electrical
wiring or plumbing. The electrical requirements are a 120-volt 60 Hz, AC
only, 15 amp. or more protected electrical supply. It is recommended that a
separate circuit serving only this appliance be provided.
The drawer is equipped with a 3-prong grounding plug, it must be plugged into a wall
receptacle that is properly installed and grounded. Should you only have a 2-prong
outlet, have a qualified electrician install a correct wall receptacle.
NOTE: If you have any questions about the grounding or electrical instructions, consult
a qualified electrician or service person.
*Can also be installed using an electrical outlet in an adjacent cabinet within the area where the
provided electrical cord can reach. Always check electrical codes, for requirements.
ELECTRICAL OUTLET
Figure 4
11
Publicité
