Publicité
Les langues disponibles
Les langues disponibles
LEVEL 4
LEVL 4
Access to level 4 is gained through UEr in level 3. Press and hold
seconds.
Enter level 4 at Lock, release
and
together. Display reads LoCK nonE
Program security using Lock
Select from three Lock options: Press and hold
LEV.3
locks level 3 and 4 only- Technical Functions.
LEV.2
locks levels 2, 3 and 4 only - Configuration and
Technical Functions.
ALL
locks all functions LoCK ALL
Note:
Locked functions and options may be read.
Press
to access following functions
Function
Options
ProG [Auto]
StAY
Program mode auto-exit switch
Auto-exit returns display to normal if 60 seconds of key inactivity, select StAY to disable
no.AL [oFF]
on
Disable SP2 alarm annunciator -AL-
Select on to disable -AL-
di.SS dir
1 to 32
Display sensitivity
dir = direct display of input 1 = maximum, 32 = minimum sensitivity
dEr.S
0.1 to 1.0
Derivative sensitivity
MECHANICAL INSTALLATION
The Controllers are designed to be mounted either in a 1/16 or a 1/32 DIN panel cutout.
The units are sleeve mounted with the front bezel assembly rated NEMA4/IP66 provided
that:
the panel is smooth and the panel cutout is accurate;
the mounting instructions are carefully followed.
Gross Automation (877) 268-3700 · www.carlogavazzisales.com · sales@grossautomation.com
and
for 10
, press
to index.
[Factory settings] shown in brackets
[6]
[0.5]
DIN PANEL CUTOUT
1/16 DIN: 45.0mm +0.6 / 0.0 wide, 45.0mm +0.6 / 0.0 high
1/32 DIN: 45.0mm +0.6 / -0 wide, 22.2mm +0.3 / -0 high
Maximum panel thickness 9.5mm
Minimum spacing 20mm vertical, 10mm horizontal
MOUNTING
To mount a Controller proceed as follows:
1 Check that the controller is correctly orientated and then slide the unit into the cutout.
2 Slide the panel clamp over the controller sleeve pressing it firmly against the panel until
the controller is held firmly.
3 The controller front bezel and circuit board assembly can be unplugged from the sleeve.
Grasp the bezel firmly by the recesses on each side and pull. A screwdriver can be used
as a lever if required.
4 When refitting the bezel assembly it is important to press it firmly into the sleeve until the
latch clicks in order to compress the gasket and seal to NEMA4X/IP66.
CLEANING
Wipe down with damp cloth (water only)
Note: The controller should be isolated before removing or refitting it in the sleeve, and
electrostatic precautions should be observed when handling the controller outside
the sleeve.
DIMENSIONS: MODELS T2032 / T2016
Model
Bezel*
Width
Height
Width
T2032
51.0
28.5
T2016
51.0
51.0
Dimensions in mm
* includes gasket
Behind Panel
Overall
Behind panel
Height
Length
Length*
44.8
22.0
116.2
106.7
44.8
44.8
116.2
106.7
9
Publicité
