CARLO GAVAZZI T2000 Serie Manuel D'instructions page 2

INDEX
FUNCTIONS MENU
GETTING STARTED
Initial Set-up
AUTOTUNE
Tune or tune at setpoint program
PROPORTIONAL CYCLE-TIME
Cycle-time recommendations
PROGRAMMER
Ramp-Soak
SECOND SETPOINT (SP2)
Error messages
FUNCTION LIST
Level 1
Level 2
Level 3
Level 4
MECHANICAL INSTALLATION
DIN panel cut-out
Mounting
Cleaning
ELECTRICAL INSTALLATION
Sensor selection
SPECIFICATION
SAFETY AND WARRANTY
2
Gross Automation (877) 268-3700 · www.carlogavazzisales.com · sales@grossautomation.com
INSTRUMENT PANEL FEATURES
3
4
4
4
5
5
5
5
5
6
6
7
Green Display:
7
Orange Display:
7
Green LED:
8
Red/Orange LED:
9
9
9
9
ADJUSTMENTS
9
10
To enter or exit program mode:
11
To scroll through functions:
11
To change levels or options:
12
To view setpoint:
To increase setpoint:
To decrease setpoint:
To reset an alarm or fault condition:
Notes: If in difficulty by becoming "lost" in program mode, press
seconds to return to display mode, check the INSTRUMENT ADJUSTMENTS above and
try again.
When in program mode, after 60 seconds of key inactivity the display will revert to
either inPt : nonE or, if the initial configuration has been completed, the measured
value. Any settings already completed will be retained.
! This page can be photocopied and
used as a visual aid and bookmark when
working in other parts of the manual.
Process temperature or program Function/Option
Setpoint temperature or program Option (T20162 only)
Setpoint 1 output indicator
Setpoint 2 output indicator
Press together for 3 seconds
Press or
Press together or
Press
Press together
Press together
Press together briefly
together
and together for 3