Publicité
Les langues disponibles
Les langues disponibles
Reduce dust exposure with the following
measures:
- Do not direct the escaping particles and the
exhaust air stream at yourself or nearby persons
or on dust deposits.
- Use an extraction unit and/or air purifiers
- Ensure good ventilation of the workplace and
keep clean using a vacuum cleaner Sweeping
or blowing stirs up dust
5. Overview
See page 2.
1 «Quick» clamping nut *
2 Support flange
3 Spindle
4 Spindle locking button
5 Sliding on/off switch *
6 Handle
7 Electronic signal indicator *
8 Thumbwheel for selection of speed *
9 Trigger switch*
10 Switch-on lock
11 Additional handle/Additional handle with
vibration damping *
12 Safety cover
13 2-hole nut *
14 2-hole spanner *
15 Lever for safety guard attachment
* deaptteanchdinmeg notn equipment/not
in scope of delivery
6. Commissioning
Before plugging in, check to see that
the rated mains voltage and mains
frequency, as stated on the rating
label, match with your power supply.
Always install an RCD with a max. trip
current of 30 mA upstream.
6.2 Attach the safety guard
For safety reasons, always use the safety
guard provided for the respective wheel !
See also chapter11.Accessories !
Safety guard for grinding
Designed for work with roughing wheels, flap
sanding pads, diamond cut-off wheels.
See illustration C on page 3.
-Push and hold the lever. (15) Place the safety
guard in the position indicated. (12)
- Release the lever and turn the safety guard until
the lever engages.
-Push the lever and turn the safety guard until the
closed section is facing the operator.
- Make sure that the guard is placed securely: The
lever must engage and you should not be able to
turn the safety guard.
(Disassemble in reverse order.)
7. Attaching the grinding disc
Prior to any conversion work: Pull the
mains plug from the socket. The ma-
chine must be switched off and the
spindle at a standstill.
For reasons of safety, attach the
cutting guard before performing
cutting-off operations (see chapter
Accessories).11.
7.1 Locking the spindle
- Press in the spindle locking button and turn the
spindle by hand until the spindle locking button
engages. (4) (3)
7.2 Placing the grinding wheel in position
See illustration A on page 2.
- Fit the support flange on the spindle. (2) The
flange should not turn on the spindle when pro-
perly attached.
- Place the grinding disc on the support flange.
(2) The grinding disc must lay flat on the suppor-
ting flange.
7.3 Securing/Releasing the «Quick» clamping
nut (depending on features)
Securing the (1)»Quick» clamping
nut:
Only attach the «Quick» clamping nut
(1) to tools with «Quick System». These
tools can be identified by the red spin-
dle lock button (4) with «Quick» logo
ENGLISH
Use only accessories that
are covered by at least
3.4 mm by the safety
guard.
EN
9
Publicité
