PURE H270SB Mode D'emploi page 22

Installing the microphone
You will need to install the included microphone to
make handsfree phone calls using Highway and your
mobile phone.
Note: Do not install Highway's microphone in noisy
areas within your vehicle, such as near air vents.
1. Loosen any trim panels.
2. Use the supplied clip to attach the microphone to
the sun visor above the driving position (A).
3. Route the cable behind the trim panels (B) and
leave the microphone connector hanging out of
the dashboard (C), ready for connecting to the
head unit.
4. Secure the cable using the supplied self-adhesive
clip.
5. Return all the trim panels to their original positions.
(A)
(C)
CAUTION: Do not route the microphone or any other
cables across airbags as they may not operate as
intended in the event of a collision. Cables should be
secured away from airbag deployment zones. Take
extra care when working around airbags.
20
Installing the Highway head unit
1. Insert the mounting sleeve into the dashboard. Fix
it firmly in place by folding down the metal tabs.
2. Connect the audio, microphone, FM/MW antenna
and electrical cables to the back of Highway (see
page 18).
3. Install the detachable panel (see opposite) and
test Highway to check that all audio functions are
working properly.
4. Connect the digital antenna cable.
Note: See page 19 before connecting the
digital antenna cable.
5. Remove the two protective screws on the top of
Highway so that the CD function works and slide
Highway into the mounting sleeve and push to
secure in place.
6. Attach the outer trim frame.
If you are not sure how to install this unit
(B)
correctly, contact a qualified technician.
Mounting sleeve
Mounting bolt
Rubber cushion
Remove the
two screws
Main unit
Trim plate
Installing the detachable panel
1. Line up the groove on the
right side of the face panel
with the slot on the unit.
2. Press down the left side of
the face plate until it clicks
into the panel slot.
Carrying out a factory reset
1. Remove the detachable panel as described on
page 5.
2. Press the RESET button with a pointed object
to reset Highway to factory settings.
3. Replace the detachable panel as described on
page 5.
Note: Pressing the RESET button will erase the
clock setting and stored stations.
1
2
2
1