Powerplus POWXG9504 Traduction Du Mode D'emploi D'origine page 25

12 TROUBLESHOOTING
Incidents
Pump does not start
No flow
Pump does not switch off ▪
Insufficient flow
Pump switches off after
short operating period
13 STORAGE
▪
Thoroughly clean the whole machine and its accessories.
▪
Store it out of the reach of children, in a stable and secure position, in a cool and dry
place, avoid too high and too low temperatures.
▪
Protect it from exposure to direct sunlight. Keep it in the dark, if possible.
▪ Don't keep it in plastic bags to avoid humidity build-up.
Copyright © 2024 VARO NV
Causes
▪
No mains supply
▪
Floater does not switch
▪
Inlet sieve is clogged
▪
Pressure hose in bent
Floater cannot sink down
▪
Inlet sieve is clogged
▪
Reduced pumping capacity
by dirty and abrasive water
▪
Thermal cutout stops
pumps due to dirty water
▪
Water too hot. Thermal-
cutout stops pump
P a g e
POWXG9504
Remedies
▪
Check mains supply
▪
Bring floater in a higher
position
▪
Clean inlet sieve water jet
▪
Reset hose
▪
Place pump properly on shaft
ground
▪
Clean inlet sieve
▪
Clean pump and replace
worn-out parts
▪
Remove mains plug. Clean
pump and shaft
▪
Make sure that a water tem-
perature of max. 35°C is not
exceed
| 6
EN
www.varo.com