THOMSON WEAR7208PU Mode D'emploi page 6

5.3. Bluetooth multipoint connection
®
This headset can be connected with two Bluetooth
terminal devices simultaneously.
• First connect the headset with the first terminal device as
described in 5.1.
• Then disable Bluetooth
®
• Next, connect the headset with the second terminal device
as described in 5.1.
• Activate Bluetooth on the first terminal device once
®
more. The headset now connects to that terminal device
automatically.
5.4. Audio playback
Note
• Note that the functions described under 5.3. and 5.4.
are only possible with an active Bluetooth
• Your terminal device must also support the individual
functions.
• For more information, please refer to the operating
instructions of your terminal device.
• Functions can still be controlled directly via the terminal
device.
• Set the volume on your terminal device to a low level.
• Switch the headset on using the MF button (5). Upon
successful connection, a voice says, "Connected".
• Start audio playback on the connected terminal device.
• Press Volume + (4) to increase the volume. There is an
announcement when the maximum volume is reached.
• Press Volume - (6) to reduce the volume.
• Press the MF button (5) to start or pause audio playback.
• Press and hold Jump forward one title (4) to skip to the
next title.
• Press and hold Jump backward one title (6) to skip to the
previous title.
5.5. Hands-free function
• Press the MF button (5) once to answer an incoming call.
• Press the MF button (5) twice or use your telephone to reject
an incoming call.
• During a call, press the MF button (5) once to end the call.
• Press the MF button (5) twice to call the number of the
last call.
Note – Call quality
To increase the call quality, make sure that you are near the
headset with your mobile phone during the call.
4
-enabled
®
on that terminal device.
connection.
®
5.6. Disconnecting the headset
• Switch the headset off.
• Disconnect the headset via the Bluetooth
terminal device.
5.7. Battery capacity
• An announcement is made and the display flashes in red
when the battery is low.
• Charge the headset as described in 4. Getting Started.
6. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and
do not use aggressive cleaning agents. Make sure that water
does not get into the product.
7. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to observe
the operating instructions and/or safety notes.
8. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
9. Recycling Information
Note on environmental protection:
After the implementation of the European Directive
2012/19/EU and 2006/66/EU in the national legal
system, the following applies: Electric and electronic
devices as well as batteries must not be disposed of
with household waste. Consumers are obliged by
law to return electrical and electronic devices as well as batteries
at the end of their service lives to the public collecting points set
up for this purpose or point of sale. Details to this are defined by
the national law of the respective country. This symbol on the
product, the instruction manual or the package indicates that a
product is subject to these regulations. By recycling, reusing the
materials or other forms of utilising old devices/Batteries, you are
making an important contribution to protecting our
environment.
settings on your
®