ULTIMATE SPEED UPM 120 C3 Traduction Des Instructions D'origine page 19

into a false feeling of security
and do not disregard the safety
rules for power tools, even if you
are familiar with the power tool
after using it many times. Acting
carelessly can result in serious injuries
within fractions of a second.
Residual risks
Even if properly operating and handling this
electric tool, some residual risks will remain.
Due to its construction and build, this elec-
tric tool may present the following hazards:
a) Lung damage, if suitable respiratory
protection is not worn;
b) Ear damage if working without ear pro-
tection.
c) Eye damage if no suitable eye protec-
tion is worn.
d) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the func-
tionality of active or passive medical
implants. To reduce the risk of seri-
ous or lethal injuries, we recommend
that persons with medical implants
consult their doctor and the manu-
facturer of their medical implant
before operating the machine.
Operation
Caution! Risk of injury!
- Always remove the mains plug
before working on the tool.
The mains cable is to run over the us-
er's shoulder during the use of the pol-
ishing machine to avoid contact with
the polished surface. This is to prevent
scratches from the mains cable.
Tighten cover on the
polishing disc
1. Align the polishing disc (3) upwards.
2. Using both hands, grab hold of a
towelling cover (5) or a synthetic fur
cover (4) and expand the elastic band
outwards.
3. Put the cover (4/5) on a part of the
polishing disc (3) over the edge of the
polishing disc. Pull the cover around
the edge.
4. Fit the cover (4/5) in centrally and
tightly around the polishing disc (3).
Switching on and off
Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type plate.
Connect the machine to the power
supply.
1. To switch on, tilt the on/off switch (2) to
position „I", the device turns on.
2. To switch off, tilt the on/off switch (2) to
position „0", the device turns off.
3. Firmly hold the device with both hands
on the handle (1).
Waxing/polishing paint
surfaces
1. Use the towelling cover (5) to apply polish.
2. Apply the wax or polish on a slightly
smaller area than the area you would
like to polish.
GB MT
19