Publicité
Les langues disponibles
Les langues disponibles
Canada, Industry Canada (IC) Notices
E
Class B digital circuitry of this device complies with
Canadian ICES-003. This device complies with Industry
Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must
accept any interference, including interference that may
cause undesired operation of the device.
Under Industry Canada regulations, the radio
transmitter(s) in this device may only operate using
an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication.
Setup
Attaching the Wrist Strap
1.
While facing the front of the tool, insert the thin end
of the wrist strap through one of the holes in the
bottom of the tool (Figure
2.
Push the thin end of the wrist strap until it goes
through the other hole.
3.
Separate the two wires, which make up the thin end
of the wrist strap, to form a loop.
4.
Insert the thick end of the wrist strap all the way
through the loop in the thin end, so the wrist strap
is securely fastened to the tool (Figure
Charging the Battery
Fully charge the battery before initial use and whenever
the tool has not been used for 6 months or longer.
1.
Locate the port cover on the side of the tool
(Figure
).
D 1
2.
Using your finger, gently pull the port cover up
(Figure
).
D 1
3.
Insert the small end of the USB Recharge Cable
into the port on the side of the tool, making sure to
insert the flat side of the cable into the flat side of
the port (Figure
4.
Insert the USB end of the cable into a USB port in a
computer or USB power outlet (Figure
6
).
A 5
).
C
).
D 2
D 3
5.
Wait approximately 2.5 hours for the battery to
fully charge and then disconnect the USB Recharge
Cable.
When the tool is ON, the battery level appears in the
display window (Figure
Operation
Measuring the Distance to an Object
1.
Point the laser at the top of the tool (Figure
) toward the wall or object whose distance you
1
need to measure (Figure
2.
Press
display the red laser dot.
3.
Press
of the tool to the wall or object (Figure
4.
At the bottom of the display window (Figure
view the current measurement (Figure
To take a new measurement, press
current measurement up to the previous line on the
display window (Figure
Measuring Distances Continuously
To take a series of measurements as you move around,
change to Continuous Measure mode.
1.
Point the laser at the top of the tool (Figure
) toward the wall or object whose distance you
1
need to measure (Figure
2.
Press
display the red laser dot.
3.
Press and hold
Continuous Measure mode.
4.
At the bottom of the display window (Figure
), view the current measurement (Figure
2
which will keep changing as you move the tool.
5.
To take the current measurement (from the bottom
of the tool to the wall or object) and exit Continuous
Measure mode, press
To take a new measurement, press
current measurement up to the previous line on the
display window. Then repeat steps 1-5.
).
).
F 1
).
E 1
(Figure
) to turn the tool on and
A 3
to measure the distance from the bottom
to move the
). Then repeat steps 2-4.
F 2
).
E 1
(Figure
) to turn the tool on and
A 3
for 4 seconds to turn on the
.
to move the
A
).
E 2
),
A 2
).
F 3
A
A
),
F 3
Publicité
