Publicité
Steps
1. Align and lower the system board into the system until the connectors at the back of the system board align with the slots on the
chassis, and the screw holes on the system board align with the standoffs on the system.
2. Replace the two (M3x4) screws and three (6-32) screws to secure the system board to the chassis.
3. Align the slot on the hard drive caddy support with system board and place the hard drive caddy on the system board.
4. Replace the screw (6-32) to secure the hard drive caddy support to the system board.
Next steps
1. Install the processor.
2. Install the speaker.
3. Install the
memory
modules.
4. Install the
heat
sink.
5. Install the
fan
assembly.
6. Install the
WLAN
card.
7. Install the
solid-state
drive.
8. Install the
hard drive
assembly.
9. Install the
front
bezel.
10. Install the
side
cover.
11. Follow the procedure in
after working inside your
computer.
Démontage et remontage
51
Publicité
