Télécharger Imprimer la page

Samsung WF393BTPARA Mode D'emploi page 20

Publicité

Les langues disponibles

Les langues disponibles

operating instructions
To reduce the risk of fi re, electric shock, or injury to persons, read the IMPORTANT SAFETY
INSTRUCTIONS before operating this appliance.
WARNING
LOADING YOUR WASHER
You can fi ll the tub with dry, unfolded clothes, but DO NOT OVERLOAD the tub. No more than 3/4 full.
Overloading may reduce washing effi ciency, cause excess wear, and possibly cause creasing or
wrinkling of the load.
Wash delicate items such as bras, hosiery, and other lingerie in the Delicates cycle with similar
lightweight items.
When washing big bulky items or a few smaller items that don't fi ll the tub completely – a rug, a pillow,
stuff ed toys, or one or two sweaters, for example – add a few towels to improve tumbling and spin
performance.
During the spin cycle, the washer may add additional water to redistribute the clothes and correct an
inbalance inside the drum.
To ensure good cleaning result when washing heavily soiled loads, do not overload your washer.
When the "Garment+
1. Press the Start/Pause Button.
2. Wait for the Door Lock light to go out (5 seconds).
3. Add the item, close the door, and press the Start/Pause Button.
After a 10-second pause, the cycle will resume.
To ensure thorough cleaning, add items within fi ve minutes of starting the wash cycle.
WASHING CLOTHES: BASIC INSTRUCTIONS
1. Press the Power button, open the door, and then load the washer.
2. Close the door.
Push the laundry into the drum completely to prevent the laundry from being caught in the door or
from falling out of the drum.
CAUTION
3. Add detergent and additives to the dispenser (see pages 27~28).
4. Select the appropriate cycle and options for the load (see pages 21~23 and 26).
5. Press the Start/Pause Button.
The drum automatically rotates and measures the weight of the laundry without supplying water in
order to adjust the wash time. (The rotating display on the display panel indicates that the weight of the
laundry is being measured.)
6. The Wash Indicator light will illuminate.
7. The estimated cycle time will appear in the display.
The time may fl uctuate to indicate the time remaining in the cycle better.
The actual time required for a cycle may diff er from the estimated time in the display depending on the
water pressure, water temperature, detergent, and laundry.
8. Before your washer starts to fi ll, it will make a series of clicking noises to check the door lock and do a
quick drain.
When the cycle is complete, the Door Lock light will go out and "End" will appear in the display.
DO NOT attempt to open the door until the Door Lock light is off . To add a forgotten item, see the
"Loading your Washer" section above.
When your washer is restarted after a pause, expect a delay of up to 15 seconds before the cycle
continues.
Pressing the Power button cancels the cycle and stops your washer.
The Pre Wash, Wash, Rinse, and Spin indicator lights will illuminate during those portions of the
cycle.
Do not place anything on top of your washer while it is running.
WARNING
20_ Operating instructions
WF395BTPA-03145B-02_EN_20120829.indd Sec5:20
WF395BTPA-03145B-02_EN_20120829.indd Sec5:20
" light is ON (see page 24), you can add or remove laundry items during a wash.
2012-08-31
2012-08-31
12:36:21
12:36:21

Publicité

loading

Ce manuel est également adapté pour:

Wf393btpa serieWf395btpa serieWf393btpawr