Publicité
Les langues disponibles
Les langues disponibles
EN
The switch is unlocked by pressing the switch at the
rear end (1). The machine switches off .
4.2 Depth adjustment Cutting depth Figure D
The depth can be adjusted from 0 to 35 mm.
► Loosen the wing nut ( 8 ) of the depth stop.
► Set the desired depth by moving the depth stop ( 9 )
and retighten the wing nut ( 8 ).
► Before starting work, check the depth setting on a test
piece.
► Check the cutting blades before use.
They must be properly mounted and free to rotate.
Perform a test run of at least 1 minute without load.
Do not use damaged, non-circular or vibrating cutting
blades. Damaged saw blades burst and can cause
injury. .
4.3 Working Advice
► Do not strain the machine so heavily that it comes
to a standstill.
► The machine may only be used for dry cutting.
– Adjust the cutting depth, see section "Pre-selectingthe
Cutting Depth".
– Guide the machine with both handles, applyingmodera-
te feed, suited to the material being worked.
– The machine must always work in an upward grinding
motion. Otherwise, the danger exists of it being pushed
uncontrolled out of the cut.
– After fi nishing the working procedure, swivel the cutting
unit out of the slot with the machine still running, until
the cutting unit engages in the uppermost position.
– Switch the power tool off .
Do not brake coasting cutting blades by applying pres
sure to the side.
► Cutting blades become very hot during
operation; do not touch them until they have co-
oled down.
WARNING!
19
Warning
When not in use, disconnect the contacts of the battery
protect. Loose metal parts can short-circuit the contacts,
there is a risk of explosion and fi re!
► For marking the power tool only use adhesive labels. No
holes into the housing.
► Spindle lock only when stationary
Press grinding tool.
4.7 Clean the dust fi lter regularly Figure
► Remove the dust fi lter and clean it with dry
Blow out compressed air.
5.0 Maintenance and Service
Maintenance and Cleaning
► Before any work on the machine itself, pull the
mains plug.
► For safe and proper working, always keep the ma-
chine and ventilation slots clean.
After fi nishing work, dismount the clamping fi xtures and
clean all clamping parts as well as the protective cover.
When the carbon brushes are worn out, the machine
switches itself off .
The machine must then be sent to an after-sales ser-
vice agent. Addresses are listed in the Section "After-
sales service and customer assistance".
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
WOLFF power tools.
In all correspondence and spare parts orders, please
always include the 10-digit article number specifi ed on
the type plate of the machine.
5.1 Spare parts
Spare parts are available on the Internet:
http://webcatalog.wolff -tools.com can be found.
CAUTION!
Publicité
