Home Decorators Collection 11252AIWNCNCA Guide D'utilisation Et D'entretien page 13

Operation
REMOTE CONTROL OPERATING INSTRUCTIONS
Install a 12V battery (N) into the remote control (L). Fasten the battery
cover screw (QQ) after installation. To prevent damage to the remote
control, remove the battery if not used for long periods of time.
WARNING: Do not short-circuit, disassemble, heat up,
connect improperly, or dispose of used batteries in fire. Do
not recharge or mix batteries with used or other battery
types. Immediately remove used batteries.
WARNING: a)The cells shall be disposed of properly,
including keeping them away from children; and
b) Even used cells may cause injury.
LEARNING PROCESS
NOTE: After the AC power is on, do not press any other button
on the remote control before pressing the
button. Doing so will cause the procedure to fail.
Should you desire to use another remote control (M) unit with your
new fan or install more than one fan in the area, please install one
by one using the steps below:
□
Turn the main power source off to begin the learning process.
□ Return the power to the unit.
□ Within 30 seconds of turning the fan's AC power ON, press and
hold the button for 5 seconds to enter the learning function.
Once the receiver has detected the set frequency, a beeping
sound is emitted when pairing is complete.
(FAN ON/OFF)
13
L
QQ
N
L
Please contact 1-844-400-FANS (3267) for further assistance.
HOMEDEPOT.CA