Beper RI.064 Manuel D'instructions page 17

EN
OPERATION OF APPLIANCE
1. Once the appliance is firmly installed on to the wall, plug it to the wall socket
2. Place the general switch found on the side of the appliance on "ON" position; a slight "BEEP" will be heard,
and the light on the control panel will turn on, the appliance will now be in "Stand-by" mode
3. Activate the remote control by removing the protective film found next to the battery case
4. It will now be possible to set the appliance as wished by using the remote control. The display will show the
light based on the selected setting.
WARNING: in case the remote control is lost, it will still be possible to operate the appliance, by pressing
the "START/STOP" button found next to the ON/OFF switch. (Only the basic settings will be available).
REMOTE CONTROL:
17