SW-Motech HDG.00.220.33200/B Instructions De Montage page 13

2
Remove the original end weights and handguards if mounted.
Make sure the handlebar ends and the inside of the handlebars are clear.
Screw the adapters (5) onto the vehicle as shown in the drawing above.
 WARNING: Use a liquid threadlocker!
Tighten the adapters (5) as specified in the mounting instructions.
Install the brackets (6/7) on to the handlebar ends as shown in the drawing
below.
To do so, tighten the screw (8) so that the brackets (6/7) can still be
readjusted.
The content translation is automated.
© SW-MOTECH GmbH & Co. KG
MOUNTING STEP · READ AND KEEP MOUNTING INSTRUCTIONS!
5
2
5
×
M 18 Nm
1
6
×
1
7
×
2
8
×
M 18 Nm
2
9
×
2
10
×
Errors and omissions excepted
Subject to technical and design changes.