Pur Line HYDRO 18 Manuel D'utilisation page 11

CONTROL PANEL
CLEANING AND MAINTENANCE
In case when the water is hard which means water contains too much calcium and magnesium, they can cause
"white powder" problem and give heavy scum on the surface of water basin, transducer and inner surface of
the water tank. Scum on the surface of transducer will make the unit work improperly.
WE RECOMMEND:
• Use filtered water or distilled water.
• Clean the transducer, water tank and basin unit every week.
• Change the water in water tank more often to keep it fresh.
• Clean the whole unit, and make sure to keep all parts of the unit dry completely when the unit is not in use.
HOW TO CLEAN THE TRANSDUCER:
for 2-5 minutes. 2. Brush out the scum on the surface. 3. Rinse the transducer with clean water.
HOW TO CLEAN THE BASIN UNIT:
scum in it. 2. If the scum is covered on the security switch, drop the vinegar on the scum and clean it out with
the brush. 3. Rinse the water basin with clean water.
CLEAN THE TANK FILTER:
Shake about 10 times and rinse with water. 4. Leave to dry.
Power
Power button: after connecting the power, touch the power key, the LCD will light
up and the machine will work. Touch the power key again, the humidifier will stop
working and enter the standby mode.
Mist Level
Mist level button: the product is divided into zero fog volume, low fog volume,
medium fog volume and high fog volume. The fog volume can be adjusted. Press
the lower fog volume key to adjust the cycle each time. The product starts up with
the maximum fog volume by default.
Humidistat
Constant humidity button: press this key for the first time, the product will enter
the constant humidity function, and the "ambient humidity" on the LCD will light
up. The default humidity is 40%, and then press 5% to increase until 90% to exit
the constant humidity function, so as to adjust the cycle, and stop working when
the ambient humidity reaches the preset humidity value.
Timer
Timer button: this product has the function of appointment timing. It can be shut
down for 1 hour, 2 hours to 8 hours. Touch this key to set the shutdown time,
and the corresponding time will be displayed on the display screen each time you
press this key.
Warm
Button that activates the warm steam function.
Sleep
Night light function: Touch and press the timer key for 3 seconds to turn on or
turn off the night light function and the night light icon will show on the display
screen.
1. Put 5-10 drops of vinegar on the surface of the transducer, wait
1. Clean the water basin with soft cloth and the vinegar if there is
1. Remove the filter from the tank. Clean with a little vinegar and clean water. 3.
EN
9