Télécharger Imprimer la page

AEG SANTO C 9 18 41-5i Notice D'utilisation page 34

Publicité

Les langues disponibles

Les langues disponibles

34
What to do if...
Problem
The temperature in the
appliance is too low/high.
The temperature in the
refrigerator is too high.
The temperature in the
freezer is too high.
There is too much frost.
Replacing the lamp
1. Switch off the appliance.
2. Press on the rear hook and at the same
time slide the cover in the direction of the
arrow.
3. Replace the lamp with one of the same
power (the maximum power is shown on
the lamp cover).
4. Install the lamp cover by sliding it into its
original position.
5. Switch on the appliance.
6. Open the door. Make sure that the light
comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Force Center.
Possible cause
The temperature regulator is not
set correctly.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not
set correctly.
Solution
Set a higher/lower temperature.
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Wrap the food correctly.
Set a higher temperature.

Publicité

loading