One for All URC-2981 Mode D'emploi page 5

Your One For All remote control can learn any function from any other wor-
king remote control. To do this, firstly make sure you have all your original
remote controls to hand, and that they have working batteries in. To learn
functions, the original remote should be approximately 3cm from the OFA
remote, pointing towards it as shown below:
1.
2.
3.
4.
5. Press and release the corresponding key on the original remote,
for example Power.
6. The red LED will blink twice to indicate the key has been learned correctly.
7. Repeat steps 4 and 5 for each key you want to learn – remember you can
learn from multiple remotes, but only one function per key.
8.
• If the red LED shows one long blink at step 6, the function was not lear-
ned correctly, please try again from step 4.
• If you find one or more keys don't work properly after set up, you
can re-enter the learning mode at any time by repeating the procedure
from step 1.
How to delete a learned function to obtain the original function?
1.
2.
3.
4. Press the key to be deleted (e.g. red key) twice.
Learning (copy)
Select the corresponding device e.g. TV
Press and hold down the MAGIC key until the red LED
underneath the POWER key blinks twice (the red LED
will blink once then twice).
Press 9 7 5
Press and release the key you want to learn a function
onto (for example the Power key) – The red LED will
blink continuously.
When you learned all the functions you require, press
and hold the MAGIC key until the red LED blinks twice.
Select the corresponding device mode (e.g. TV).
Press and hold down the MAGIC key until the red LED
underneath the POWER key blinks twice (the red LED
will blink once then twice).
Press 9 7 6.
2 - 5 CM
5