GMC-I PRO SyS ACP 1000/2 Notice D'utilisation page 5

______________________________________________________________
2. INTRODUCTION
The ACP 1000 and ACP 1005 are AC current probes utilising
Rogowski principle. They can be used to measure AC current up
to 1000A, when used with oscilloscopes, recorders or data
loggers. The flexible probe allows current measurements on
conductors that are hard to reach.
The probes provide a 1V full scale AC output proportional to the
current being measured with three selectable ranges.
_______________________________________________________________
3
1
7
2
Fig 1
1. Probe Coupling
2. Probe Output Cable
3. Flexible Current Probe
4. Power On / Range Switch
5. RED LED – Overload
6. ORANGE LED – Low Battery
7. External Power Supply Input (ACP 1005)
8. Integrator Housing
9. Output Cable
2
4
5
6
8
9
4