GMC-I PRO SyS ACP 1000/2 Notice D'utilisation page 4

______________________________________________________________
Read all instructions completely before using this product.
To avoid electric shock:
• Use caution during installation and use of this product; high
voltages and currents may be present in circuit under test.
• This product must be used only by qualified personnel practising
applicable safety precautions.
• Do not install this product on live conductors.
• Always de-energise circuit under test before installing flexible
measuring head. Always inspect the electronics unit, connecting
cable, and flexible probe for damage before using this product.
• Do not use product if damaged.
• Always connect electronics unit to display device before installing
the flexible measuring head.
• Never change batteries while measurement head is installed on
conductor.
• Never connect or disconnect the external power supply while the
measurement head is installed on a conductor.
• Never connect the output to any equipment with a common mode
voltage to earth greater than 30 Volts.
• Always wear protective clothing and gloves if hazardous live parts
are present in the installation where the measurement is carried
out.
• If the probe is used in a manner not specified by the manufacturer
the protection provided by the equipment may be impaired.
_______________________________________________________________
3