Charging The Power Pack; Led Light - Hama 00136692 Mode D'emploi

Warning
• The order of positive pole and negative pole
must be observed when connecting and
removing the pole terminals.
• The jump starter is only suitable for use with
12 V car batteries.
• Pole terminals must not touch each other.
Warning – BOOST button
• The BOOST button must only be used if the
status LED is not lit after connecting the jump
starter to the car battery. In other cases, the
BOOST button must not be used!
• When the Boost button is pressed, the pole
terminals are connected directly to the built-in
battery, meaning there is no longer any reverse
polarity protection. In the case of short circuit
or reversed polarity of the pole terminals, there
is an acute risk of explosion or fire!
• After a successful start attempt, please remove the
jump starter from the car battery immediately. First
release the black pole terminal from the negative
pole; then release the red pole terminal from the
positive pole. Lastly, disconnect the jump lead from
the jump starter.
• Please note that a maximum of three start
attempts may be performed. Each start attempt
may last a maximum of 5 seconds. Wait at least 10
seconds between each start attempt. If after three
start attempts the vehicle engine still does not run
on its own, abandon the start attempt.
• It is then obvious that the vehicle has a defect that
is preventing the start attempt. Please have the
vehicle checked by a specialist workshop.
6. Power pack

6.1 Charging the power pack

• Make sure that your mobile device supports
charging at 5V / 2A.
4
• Charge the device before starting it up for the first
time. Connect the included Micro-USB cable to the
USB input (2) of the jump starter and to a suitable
USB charger (at least 5 V / 2 A ; not included in
delivery package).
• Alternatively, use the supplied 12 V USB vehicle
charger to charge the device via the cigarette
lighter connection of your vehicle.
• Charging begins and ends automatically.
Note
Do not leave the device unattended for a longer
time period during charging!
6.2 Charging terminal devices
• Connect the included Micro-USB cable to the USB
output (4) of the jump starter and to the Micro-
USB port of your terminal device (smartphone,
tablet, etc.)
• The included USB cable may not be suitable for
the USB port of your terminal device. In this case,
use the USB cable that was included with your
terminal device.
• Press the Power button (1) to start the charging
process. The status LEDs (3) show the remaining
capacity of the power pack when charging.
• The jump starter switches off automatically after
charging.

6.3 LED light

• To switch on the work light, press and hold the
Power button (1) for at least 3 seconds.
• Press the Power button (1) firmly to select, in
turn, the various light modes: Continuous light -
Stroboscope - SOS light
7. Switching off the jump starter
The jump starter has an automatic switch-off
function. Once it is no longer connected to the car
battery, or the charging of mobile devices has been
completed, it automatically switches to idle mode.