PLAYTIVE JUNIOR 327458 1904 Notice De Montage page 8

• Children may only play with the product
under adult supervision.
Safety information for use
• The product may not be used in the dark or in
conditions of poor visibility!
• The product may not be used on sloping ter-
rain, near steps or stretches of open water!
Avoid danger areas!
• The product may not be used in snow or in
wet or icy conditions.
• Bear in mind that children often are not yet
able to judge their own abilities and certain
risks adequately! Because of children's need
to play unforeseeable situations may arise for
which the liability of the distributor / manufac-
turer is excluded.
• Show the child how to use the product prop-
erly and draw his/her attention to any likely
dangers!
• The child must at all times be able to control
the braking of the product safely.
Practise braking using the feet before using
the product.
• Smooth surfaces bring the risk of sliding!
Remember that when using the product there
is always the risk of a crash.
Assembly
WARNING!
Assembly of the product must always be perfor-
med by an adult!
WARNING!
During assembly keep children away from the
product and the packaging material. There is a
risk of choking since small parts can be swallo-
wed or inhaled and also of suffocation because
of plastic bags.
Front wheel assembly (fig. B)
1. Press the two spacers (12) into the rim of the
front wheel (7).
2. Secure the front wheel (7) to the fork with two
washers (11) and the axle bolt (10).
3. Fasten the axle bolt in place with the cap nut
(13) using the two tools (16).
10 GB/IE
Make sure that the cap nut is firmly
screwed onto the axle bolt.
Frame assembly
1. Place the T-connection piece (9) onto the fork
(8) (fig. C).
2. Place the frame (6) onto the fork (8) (fig. D).
Note: When positioning the frame the
pre-assembled clamp for the saddle must point
upwards.
Make sure that the notch is inserted into
the specified guide-way.
Handlebar assembly
1. Push the clamp (3) onto the fork (8) (fig. E).
2. Put a cap (4) on the handlebar (2) (fig. F).
3. Insert the handlebar into the fork (fig. G).
Stay within the maximum pull-out
height marked on the handlebar!
4. Tighten the nut on the clamp firmly with the
aid of the two tools (16) and push the cap
over the clamp.
Attaching the crash guard (fig. H)
Attach the crash guard (1) to the handlebar (2)
with the hook-and-loop fastener.
Saddle assembly
1. Put a cap (4) on the saddle with saddle tube
(5) (fig. I).
2. Insert the saddle with saddle tube into the seat
post on the frame (6) (fig. J).
Stay within the maximum pull-out
height marked on the saddle tube!
3. Tighten the nut on the clamp firmly with the
aid of the two tools (16) and push the cap
over the clamp.
Attaching stickers
Pull the stickers (14) and (15) off and attach
them to the frame.
Adjustments
Handlebar height (fig. K)
Stay within the maximum pull-out
height marked on the handlebar!
Push the cap up.
Loosen the clamp until the handlebar can be
pushed upwards and downwards and adjust the
handlebar to the appropriate height.