Publicité
Hardware Usage Guide
HOW TO USE A TWIST-LOCK
1.
Push a TWIST-LOCK® FASTENER
into the large hole in the part.
Step 2
å
Assemble your unit on a carpeted floor or on the empty
carton to avoid scratching your unit or the floor.
å
Insert four WOOD DOWELS (42F) into the exact holes
shown in the MODESTY PANEL (E).
å
NOTE: You may need to gently tap the WOOD DOWEL
in with your hammer.
42F
www.sauder.com/commercial-office/service
FASTENER
®
2.
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
E
427440
Dowel end
42F
Page 7
Publicité
