Publicité
Install the RDO cap on
the sensor.
3
Install the pH/ORP Sensor or ISE Sensors.
Remove tape and cap
from sensor.
4
Prepare Instrument for Deployment.
(Optional) Install
restrictor with vent holes
at base of instrument for
calibration.
5
Connect the Rugged Cable and communication device.
Remove protective caps
from instrument and
cable.
1-800-833-7958
Insert RDO sensor into
instrument sensor port.
Apply a pea-sized drop
of lubricant to sensor
O-rings.
(Optional) Calibrate
sensors. Calibration
procedures may be
found in user manual.
O-ring
Apply a pea-sized drop
of grease to the O-ring.
Tighten screw at base of
sensor with hex wrench.
Do not overtighten.
Insert sensor in empty
sensor port.
After calibration, flip the
restrictor with the vent
holes away from the
center of the instrument.
Align the flat edges
of the instrument
connector and the cable.
2
Tighten screw at base of
sensor with hex wrench.
Do not overtighten.
Install the end cap
on the restrictor for
deployment.
Slide connector into the
cable end.
www.geotechenv.com
Publicité
