Publicité
Les langues disponibles
Les langues disponibles
Leg Assembly:
Four (4) legs Twelve (12 screws
Tools required: Phillips Screwdriver
(Not Included)
Lay stove upside down on a padded surface to avoid scratches to the surface of
your stove.
Line up holes in the leg with holes in the underside of the stove body. With the use
of the screwdriver secure leg with the screws provided (3 screws per leg) as shown
in the figure below.
Overheating safe device
If the heater stops working, turn the heater off and inspect the blockage of inlet or
outlet. Disconnect the plug and wait at least 10 minutes for the protection
system to reset before attempting to restart the heater. If the safe device still
switches the heater off and makes the heater fail to operate, take the heater to your
nearest service center for examination or repair.
Attention: before restarting the heater, the plug must be disconnected for at
least 10 minutes
Cleaning:
1. Always disconnect the appliance from the main supply before cleaning.
2. Clean the outside of the heater by wiping with a damp or dry cloth.
3. Do not use petroleum, any other detergent or chemical solvent to clean the
heater.
4. When the heater is not used for a long time, it should be protected from dust and
stored in a clean dry place.
Disposal:
Environmental Protection.Waste electrical production should not be
disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
WARNING: Do not use this heater
with missing, damaged, or broken
legs.
3
Publicité
