Prestigio Maggiore PWO104GD Guide Rapide page 9

PWO104GD, PWO104GD_EN, PWO104SL, PWO104SL_EN
Preparing for Use
Open the package and take out the device and accessories. Remove any packaging materials. Fully charge the
device: place the wine opener on the charging station (5) so that the charging contacts (7) of the wine opener
align with the station's contacts, connect the USB Type C cable (4) to the connector of the charging station (6)
and then to the power supply * (see Fig. II). The charging process takes about 3 hours.
ATTENTION! Power adapter is not included. The output parameters of the adapter must be 5.0 V (DC) /
380.0 mA.
Using the Device
1. Put the wine bottle on a flat, horizontal surface.
Note. Bottle neck diameter: max. 33 mm; cork diameter: max. 22 mm.
2. Remove the foil from the bottle neck: take the wine opener and detach the foil cutter (1) by pulling the wine
opener by its top part (see Fig. III-1), clamp the bottle neck with the cutter, its cutting blades facing down, and
twist the cutter (see Fig. III-2).
Note. The foil cutter is attached to the wine opener by magnets.
3. Place the wine opener on the bottle neck (see Fig. III-3).
Note. Make sure that the wine opener stays in an upright position while uncorking the bottle.
4. Remove the cork:
 from the bottle: push the wine opener down onto the neck for 8 seconds until the cork is completely removed;
 from the wine opener: remove it from the neck and hold it for 11 seconds (see Fig. III-4).
Note. If the wine opener is not working, press and hold the cork removal/ejection button (2) until it starts running.
Troubleshooting
The wine opener stops during the uncorking process. Possible cause: low battery charge. Solution: charge
the device.
* The term "power supply" means a power adapter, desktop computer, laptop, tablet, etc.
©Prestigio
9