Télécharger Imprimer la page

Uline H-11513 Manuel D'instructions page 2

Publicité

Les langues disponibles

Les langues disponibles

3. Position H-Stand at end of conveyor frame. Insert
3/8 x 1¼" bolts through conveyor and H-Stand top
plate. Secure with washers, 3/8" flange nuts and
14 mm wrench. Repeat for all H-Stands.
(See Figure 3)
NOTE: It is recommended to flip conveyor
upside down for ease of installation.
Figure 3
Conveyor Frame
4. Attach pivot brace to conveyor between H-Stands
with 3/8 x 1¼" bolts, washers and 3/8" flange nuts.
Repeat for opposite side. (See Figure 4)
NOTE: Do not fully tighten bolts and locknuts.
Figure 4
Bolt
PAGE 2 OF 6
ASSEMBLY CONTINUED
H-Stand
Flange Nut
Pivot Brace
1-800-295-5510
uline.com
5. Attach knee braces to H-Stands and center pivot
brace with 3/8 x 1¼" bolts, washers and 3/8" flange
nuts. (See Figure 5)
NOTE: On 5' conveyors, one knee brace will
attach to back (inside) of pivot brace, and one
knee brace will attach to the front (outside) of
pivot brace. (See Figure 5)
NOTE: Figure 5 shows two sets of knee braces
installed.
Figure 5
Knee
Brace
6. Tighten all bolts and flange nuts.
0624 IH-11513

Publicité

loading