LTC ATM6500BT Manuel D'utilisation page 4

ENGLISH
MIC1 VOL: Use this knob to adjust the volume of microphone 1
MIC2 VOL: Use this knob to adjust the volume of microphone 2
MIC Treble: Use this knob to adjust the treble of microphone
MIC Bass: Use this knob to adjust the bass of microphone
ECHO: Use this knob to adjust the echo of microphone.
Master Volume: Use this knob to control the master volume
OPERATION
•
Select a central location for the amplifier.
•
Connect the speaker wires (red & black) to the + and – terminals on the rear panel of the amplifier.
•
Connect the audio signal to the relevant sockets with the correct polarity.
•
Plug the mains lead in and switch the amplifier on once you have checked all connections.
•
Switch the audio sources on and adjust the master volume to the required level.
•
Karaoke: Plug a mic into MIC1 or MIC2 socket on the front panel. Before you use the mic, make sure that it
is switched off and the MIC volume button is set to the minimum. Connect the microphone, switch it on and
adjust slowly the volume and the echo.
•
If you don't use the unit any longer, switch the amplifier off and disconnect it from the mains.
Signal Sources and their Connections:
•
Connect a DVD-player or a CD-player to the terminal AUDIO INPUT or a data storage unit to the USB-interface
or insert a SD-memory card in the suitable slot or activate the Bluetooth function on your smartphone.
•
Select the active signal source by pressing the INPUT button until the desired input source is displayed.
•
Use the MP3 CONTROL-function for controlling the files on a connected data storage unit.
•
If you wish to use the karaoke function of this device, insert one or two microphones into MIC1 and MIC2.
Their signals are going to the signal output too.
BLUETOOTH CONNECTION
The ATM6500BT is only discoverable when the input selected is Bluetooth. After selecting Bluetooth input mode
on the ATM6500BT, turn on the Bluetooth function on the cell phone and search the ATM6500BT. Its Bluetooth
device name is "ATM6500BT". Pair and connect after search. There is no pairing code.
REAR PANEL:
Power supply: Connect the unit to the power outlet.
Main Speakers Outputs: Connect your speakers here to receive the signal from the ATM6500BT
DVD Input: Connect your DVD or CD or any other passive signal here.
AUX Input: Connect your DVD or CD or any other passive signal here.
FM Antenna: Connect your FM antenna here
4
CAUTION - VORSICHT - ATTENTION - OPGELET
Shock hazard - Do not open the housing
Stromschlaggefahr - Nicht das Gehäuse öffnen
Risque de choc électrique - Ne pas ouvrir le boîtier
Risico voor elektrische schok - Niet de behuizing openen
~
© Copyright LOTRONIC 2024
~