LTC ATM6500BT Manuel D'utilisation page 3

 Skip forwards
Number buttons from 0-9: Press to select directly a title/track number
10-/10+: Press to skip forwards or backwards in steps of 10
INSTALLING THE BATTERIES IN THE REMOTE CONTROL
•
Place the remote face down on a flat surface.
•
Push the compartment cover into the direction of the arrow.
•
Slide the battery compartment open.
•
Remove the old battery and install the new one (CR2032) with the plus (+) symbol facing up.
•
Gently slide the battery compartment closed. It locks automatically.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in
accordance with your local regulations. Batteries shall not be exposed to excessive heat such as sunshine, fire or the
like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
WARNING: The supplied remote control contains a button cell. In case of ingestion, it might cause serious internal burns with-
in only 2 hours that might lead to death. Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact imme-
diately a doctor.
Features
•
USB/SD card input
•
Spectrum Screen Display
•
2x microphone inputs with Echo & Volume control
•
FM tuner
•
Bluetooth function
Front panel
POWER: Press this button to power ON or OFF the unit
Play/Pause & Scan: Press this button to play the signal from USB/SD, Bluetooth. Press again to pause. In tuner
mode, press this button to scan all the available stations from the lowest frequency to highest frequency.
Previous: Press this button to go back to the beginning of the current track or move to the previous track.
Next: Press this button to move to the next track.
/ Repeat/Random: Press this button to select the repeat mode between REPEAT ONE, REPEAT ALL, RAN-
DOM. The default setting is repeat all.
Input: Press this button to cycle through the various inputs.
USB: Connect your USB flash drive here
SD: Connect your SD card here
DELAY: Use this knob to adjust the delay of microphone.
EQ MODE: Press this button to cycle through the pre-set equalizer modes.
Audio Function: Press this button to switch the control mode between bass, treble & master volume
MIC1 & MIC2: Connect your microphones here
ATM6500BT (10-7053)
www.lotronic.net
3