Rotaid SOLID PLUS HEAT LED Guide D'installation page 11

ROTAID SOLID PLUS HEAT LED
Instruction sheet A.
WATCH OUT!
ATTENTION!
Follow the instructions!
*Possible chance of damaging the product.
+ Brown
Attach a connector plug to the cable.
Cut the cable to length and strip the outer cable
1.
(about 2 centimeters).
Remove 5 mm of the brown and blue isolation
2.
to unveil the copper wire. Cut off the green-yellow
cable completely (if present).
Place the crimp sleeve insulator over
3.
the connection wire. The cable can also be insulated
with tape (after connection).
Connect the wires to the connector.
4.
Insulate the wires via the sleeve insulator or tape.
5.
Now connect the plug to the connector that
6.
is attached to the transformer. Plug the power cable
into the wall outlet.
Immediately after installation, the heating system
7.
will go into start-up mode and perform a full system
check. Part of this check is that the heater will go to
its maximum output for a limited time. As a result
of this, the heating mat will become hot. When the
system check is successfully finished, the LEDS will be
on constantly and the system will go into stand-by
mode and its surface temperature will drop. When
the system check fails, the LEDS will start to blink.
You can then contact your Rotaid partner for further
assistance.
1. 2.
minus Blue
3.
Note:
Place the
transformer
inside at
all times!
4
11.