English Instructions - Rotaid SOLID PLUS HEAT LED Guide D'installation

ROTAID SOLID PLUS HEAT LED

English instructions

PLEASE NOTE: Only a certified
company or electrician should
install the cabinet because
of an electrical installation.
The heating is not ready
for use yet!
1. Determine the location
where you wish to mount the
Rotaid. Make sure there are no
irregularities present at the desired
location. Please take the fire safety
and evacuation regulations into
account. If mounted on a stone
or concrete wall, please use the
wall anchors prior to fixation.
To ensure the defibrillator
stays within its operational
temperature range during the
whole year, the Rotaid should be
located in the shade at all times.
2. Use the paper mould to mark
the holes for mounting the back
plate, 4 in total. Please also mark
the additional hole to house
the power cable.
3. On the bottom-left of the back
plate an eye is located. Use an awl
or screwdriver to puncture
the sealing plug. Run the whole
cable of the heating element
through the hole.
Do not attach the heating
element to the back plate yet!
10.
4. Attach the back plate by using
the four screws. Next, remove
the red layer on the back of the
heating device and fixate the
heating system to the backplate.
When correctly placed, the control
unit on the heating device is at the
bottom left side.
5. With the back plate fixed to
the wall, now use an Allen key
(5mm) to firmly attach the nylon
belt to the back plate.
6. After attaching the belt and
cover, now please mount both
long bolts in the indicated
holes. Mount these by hand
via a screwdriver and do not
overtighten. You can now hang
the AED via its handle on the bolts.
Make sure the backside of
the AED is as close as possible to
the heating system.
7. You can now place the AED into
the cabinet by using its handle or
carrying case handle. Please rotate
the cover on the back plate by
starting slightly counterclockwise
and rotate to the left until the
cover reaches the stop.
When correctly placed, the hook
on the bottom of the cabinet falls
through the cover.
Continue to
instruction sheet A.