Hefter CLEANTECH TURNADO 45 Mode D'emploi page 24

Folding down the steering column
To reduce the space requirements for
transport and storage, the steering column
can be folded down.
 Release the star knob for the transport
position.
 Swivel the steering wheel forwards.
 Tighten the star handle.
Transport
CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
 Remove the brush to avoid damage to
the brushes.
 Lift the appliance using the transport
handles.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Shutting down
 Completely charge the battery prior to
longer operational breaks extending
over several weeks.
 Set the appliance switch to "0".
ATTENTION
Risk of damage to the battery due to total
discharge.
Always switch the power switch to "0" dur-
ing operational breaks.
CAUTION
Risk of personal injury or damage! Consider
the weight of the appliance when storing it.
This appliance must only be stored in inte-
rior rooms.
24
Storage
Care and maintenance
DANGER
Risk of injury. Turn the appliance switch to "0"
and pull the mains plug of the charger prior to
performing any work on the appliance.
ATTENTION
Risk of damage for the appliance due to
leaking water. Drain the wastewater and re-
maining fresh water prior to performing
tasks on the appliance.
 Park the machine on an even surface.
Maintenance schedule
After the work
ATTENTION
Risk of damage. Do not sluice the appli-
ance with water and do not use aggressive
detergents.
 Drain off dirt water.
 Open the cover of the fresh water reservoir.
 Remove the EPA filter (optional) and al-
low it to dry outside of the appliance.
 Rinse the inside of the cover and the
float with water.
 Rinse the waste water tank with clear
water.
 Clean the vacuum bar.
 Remove bulk waste container and emp-
ty it.
 Clean the outside of the appliance with
a damp cloth which has been soaked in
mild detergent.
 Clean the vacuum lips, check for wear
and replace them if required.
 Clean brush.
 Check the brush for wear and replace if
required (see "Maintenance tasks").
 Charge battery if required.
EN – 8