Anslut 028179 Traduction Des Instructions D'origine page 9

1 Introduction
1.1 Product description
The product is a globe light that can be connected to Anslut
connectable system 24 V and can be combined with other
armatures in the same series
1.2 Intended use
The product is intended to be used to spread an
atmospheric light in the garden. The product is not intended
to be used as a general lighting.
1.3 Symbols
Read the operating instructions carefully
and make sure that you understand the
instructions before you use the product.
Save the instructions for future reference.
Safety class III
Non-replacable control gear.
Non-replacable light source.
This product complies with applicable EU
directives and regulations.
Recycle as electrical waste.
2 Safety
2.1 Safety definitions
Warning! If you do not obey these instructions, there
is a risk of death or injury.
Caution! If you do not obey these instructions, there
is a risk of damage to the product, other materials or the
adjacent area.
Note! Information that is necessary in a given situation.
8
2.2 Safety instructions for operation
Warning! If you do not obey these instructions, there
is a risk of death or injury.
● Read the warning instructions that follow before you use
the product.
● For outdoor use.
● Do not allow any children or anyone who is unfamiliar
with the product to use it.
● Do not look directly into the light source.
● Do not subject the power cord or wires to mechanical
stress.
● The product must not be connected directly to a power
outlet without a transformer.
● Do not use the product if it is damaged.
● Do not modify the product.
● The light source of this product is not replaceable, when
the light source reaches its end of life the whole product
must be replaced.
● Do not attempt to repair the product if it has been
damaged in any way. Contact an authorised service
centre.
● The product must only be used for its intended purpose.
3 Installation
3.1 To install the product
1
For installation in soil use the ground spike. (Figure 1)
2
For installation on wood or concrete use the lamp
bracket. (Figure 2)
4 Operation
Warning! Do not exceed the power capacity of the
power outlet of the transformer.
Warning! Only use extension cables for outdoor use.
Scan the QR code to view an example on how you can
connect armatures. (Figure 3)
1
Connect the product to a transformer.
2
Plug the power cable to a power outlet.
3
Use extension cable if necessary.