Nakayama NS4010 Mode D'emploi page 6

EN
Figure 7-4
1. Throttle Switch
2. Open Position of the Throttle Switch
3. Drain plug
4. Pulling Cable Assembly
Figure 7-6
Stopping the engine
When running engine, keep yourself far away from the muffler and don't face exhaust outlet for your health. Pay attention
to abnormal state of the engine during operation. If the engine produces abnormal sounds or vibrates intensely, stop the
engine at once.
CAUTION
Emergency stopping the engine: Set the stop switch to the OFF position. Correct procedure for stopping the engine is as
follows: First remove the load, idle run for 2-3 minutes, then, set the stop switch to the OFF position. The machine will
stop at once.
CAUTION
Don't directly stop the engine without removing load in normal condition.
6
1. Butterfly nut, 2. Air cleaner cover, 3. Butterfly nut
4. Paper filter-element, 5. Foam filter element, 6. Gasket
7. Cleaner base plate.
Starting the Engine
a. Open the throttle switch, close the choke, adjust the throttle valve to proper
position, first, slightly pull the starting handle till feeling a little resistance, then
pull forcefully to start the gasoline engine.
b. After starting, let the engine run 1-3 minutes at idle speed, meanwhile, check
the engine working condition whether it runs stably or smoothly and there is
any abnormal noise, then open the choke to maximum and adjust the
throttle opening to obtain required speed.
1. Choke
2. Set choke to off
position
WWW.NIKOLAOUTOOLS.COM
Figure 7-5
Figure 7-7
Stop Switch