Publicité
pottery barn kids – PBteen – Pottery Barn – west elm – Williams Sonoma – Williams Sonoma Home – Rejuvenation – Mark and Graham
20-Apl-2023
ENGLISH
CAUTION:
BEFORE INSTALLING FIXTURE, MAKE SURE THE POWER TO THE CIRCUIT IS TURNED OFF AT THE
MAIN FUSE BOX / CIRCUIT BREAKER UTILITY BOX.
Important Safety Instructions:
These instructions are provided for your safety. It is very important that they are read carefully and
completely before beginning the assembly and installation of this lighting fixture.
We strongly recommend that a professional electrician install all direct wire fixtures.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODES
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
The lighting fixture is meant for indoor use. It must be connected only to 3-wire, single-phase electrical
supply systems (provided with Ground wire or equivalent protection system).
For your safety, it is strongly recommended that two people install the lighting fixture.
This fixture has been rated for up to one (1) 60-watt maximum TYPE A standard incandescent light bulb
(not included) or one (1) 13-watt compact fluorescent light bulb (not included) or one (1) 9 watt LED bulb
(not included)To avoid the risk of fire, do not exceed the recommended lamp wattage.
To avoid the risk of fire, do not exceed the recommended lamp wattage.
for indoor or protected/covered outdoor areas. Do not expose to direct rainfall. SUITABLE FOR DAMP
OR DRY LOCATIONS.
Save these instructions.
WARNING:
To reduce the risk of fire, electrical shock or personal injury, always turn off light fixture and allow it to
cool prior to replacing light bulb.
Do not touch bulb when fixture is turned on. Do not look directly at lit bulb.
Keep flammable materials away from lit bulb
This lighting fixture contains lead, a chemical known to the State of California to cause cancer, birth
defects and other reproductive harm. Wash hands after installing, handling, cleaning or otherwise touching
this light fixture...
After installing the fixture, caulk the upper and side of the BACK PLATE (13) to the mounting surface. It is
recommended that an exterior caulking material be used, which can be found in most hardware store.
Pre-assembly:
Remove all parts and hardware from box along with any plastic protective packaging.
Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts
or hardware.
For your safety and convenience, assembly by two people is recommended.
Care instructions:
•
Wipe clean with a soft, dry cloth or static duster.
•
Always avoid the use of harsh chemicals or abrasive cleaners as they may cause damage to the
fixture's finish.
Williams-Sonoma Inc.
Assembly Instructions
Instructions d'assemblage
nstrucciones de Ensamblaje
2/13
The lighting fixture is intended
USA – A – LTBS
Publicité
