Publicité
pottery barn kids – PBteen – Pottery Barn – west elm – Williams Sonoma – Williams Sonoma Home – Rejuvenation – Mark and Graham
20-Apl-2023
To Make the Wire Connections:
1. Gently pull existing wire down from the ceiling junction box and allow wires to hang. The HOT or LIVE wire is
usually black. The NEUTRAL wire is usually white. Check to see if there is a ground wire that is usually
green or green with a yellow stripe or exposed copper metal wire. If need, use a pair of wire strippers to
remove about 1/2 inch of insulation from each wire.
2. Carefully inspect the fixture wires. The NEUTRAL FIXTURE WIRE IS THE ROUGH LONGITUDINAL
RIDGES BLACK WIRE. The HOT FIXTURE WIRE is SMOOTH BLACK WIRE, and the GROUND WIRE is
BARE COPPER WIRE. If you have any doubt and cannot identify the power-supply wires with confidence,
then we recommend that you ask an electrician and that you not continue with the installation.
3. With the help of another person to hold the weight of the fixture, attach the fixture wires to the junction
box wires as shown in the illustrations.
NOTE: IT IS IMPERATIVE THAT THE JUNCTION BOX IN YOUR HOME BE PROPERLY GROUNDED!
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE
COMPROMISED.
4. Check the wiring connections and if all looks good, gently tuck the wire connections neatly into the ceiling
junction box.
Williams-Sonoma Inc.
Connect the GROUND FIXTURE WIRE to the
GROUND
J-BOX
insulation of bare wire) using the Plastic Wire Nut
Connector (A) and wrap the connection with
electrical tape. Be sure that no wire strands are
exposed.
If the junction box DOES NOT have a GROUND
WIRE, wrap the fixture's bare ground wire around
the Green Ground Screw (B) and insert the screw
into the Mounting Plate (E), marked as "GND", and
tighten screw to secure the wire.
Connect the NEUTRAL FIXTURE WIRE to the
NEUTRAL
J-BOX
insulation)first and then connect the HOT FIXTURE
WIRE to the HOT
J-BOX WIRE (usually black
insulation)using the Plastic Wire Nut Connectors (A).
Wrap these connections with electrical tape. Be sure
that no wire strands are exposed.
Assembly Instructions
Instructions d'assemblage
nstrucciones de Ensamblaje
10/13
WIRE
(usually
green
WIRE
(usually
white
USA – A – LTBS
Publicité
