Power Dynamics PDC90 Manuel D'instructions page 4

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging. If the device has been exposed to
drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might
damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
FRONT PANEL
1. LCD Display
LCD display shows mode, volume
2. USB port
Port for USB stick, USB card reader or compatible external hard drive for playback
3. AUX input jack
This stereo AUX input is for using CD, DVD-players, Tape Decks or other line source
4. Mode
Press this button to select the mode: LINE IN/BT/DAB
DAB mode is indicated on the display as frequency
5. Previous
Press to get back to previous track
Press and hold to decrease the volume
6. Pause/Play
Press to start/resume or pause
Press in DAB mode for scan
7. Next
Press to get to next track
Press and hold to increase the volume
8. Repeat
Press this button to repeat the track, folder, all tracks or not repeat
9. Mute
Press to (un)mute for any source
10. IR sensor
Receive the IR signal from the remote control
11. MP3 volume control
Rotate to adjust volume level control of MP3-player. Always turn back the MP3 level control to the minimum before switch on
12. Mic/line 1 volume level control
Rotate to adjust volume level control of line 1/ mic 1 input. Always turn back the level control to the minimum before switch
on
13. Mic/line 2 volume level control
Rotate to adjust volume level control of line 2/ mic 2 input. Always turn back the level control to the minimum before switch
on
14. Mic/line 3 volume level control
Rotate to adjust volume level control of line 3/ mic 3 input. Always turn back the level control to the minimum before switch
on
15. AUX 1 level
Rotate to adjust volume level control for aux 1, Always turn back the level control to the minimum before switch on
16. AUX 2 level
Rotate to adjust volume level control for aux 2, Always turn back the level control to the minimum before switch on
17. Bass
Rotate to adjust the low (bass) frequencies, maximum increase +10 dB or maximum decrease of -10 dB
18. Treble
Rotate to adjust the high (trebble) frequencies, maximum increase +10 dB or maximum decrease of -10 dB
19. Master
Rotate to adjust the master volume. Always turn back the output volume control to the minimum before switch on
20. Led indicators
The current system operation is indicated on the 6 digit LED bar graph. The LED's monitor shows the current output level
within a range of -20 dB and 0 dB
4