Costway ES10302US Mode D'emploi page 10

Operation
1. Turn ON
In the standby state, press the key, the buzzer will sound twice, the
LED display window will light up, and the current ambient humidity
value will be displayed, and the machine willstart according to the
memory state and set value.
2. Temperature setting
In the non-setting state, press the set key once to enter the humidity
setting mode, and the humidity display digital tube blinks, press down
or up to adjust the setting value, and set the humidity to increase or
decrease by "1" RH every time the buzzer rings. After continuously
holding for 2 seconds, the set humidity can be continuously increased
or decreased. (Set range: 20% to 90%)
3. Timer
Press the set key,time display digital tube blinks,then press down or
up to adjust the set value, every time the buzzer sounds, the set time
increases or decreases by 1 H. After continuously holding for 2
seconds , the set time can be continuously increased or decreased.
(The value range is 0 to 24H, the default is 0H.)
4. Drainage function of pump
When the water is full, the water is automatically drained. If E6 is
displayed, the water pump is faulty.
5. Power off memory function
The controller has power off memory function. When the system
suddenly loses power during operation,automatically store the current
operating status and set parameters, timing no memory,on the next
power-on, the system automatically enters the state before the power
failure and continues to run.
18
ERROR
"E1": If the copper head sensor failure, it will show
"E1". The system works in cycles of dehumidification for 20 minutes
and defrosting for 15 minutes. Copper headsensor should be replaced
with a new one.
"E2": If the humidity sensor got failure, it will show "E2".
The humidity adjusting button will not work. The system works in
cycles of dehumidification for 30 minutes and defrosting for 15
minutes. Failure
humidity sensor should be replaced with a new one.
"F6": When the water tank is full, it will show "F6".
The machine will make a buzzing sound and stop working.
Remove the water form the tank and installed properly.
Safety precautions
1. The operating temperature of the machine is 5-38 degrees Celsius.
2. When the dehumidifier works, the compressor runs to generate
heat , and the room temperature will rise.
3. The air outlet or intake must be at least 50cm away from the wall.
4. Abnormal shutdown, the compressor has three minutes of self
-protection function. That is, after restart the machine, the compressor
restart will take another three minutes.
5. When working at low temperature, the dehumidifier automatically
determines the system temperature, so as to achieve automatic
defrost, defrost indicator light. When the fan works, the compressor
automatically stops working.
6. The accumulated dust of the air filter will affect the wet effect and
must be cleaned regularly at least once a month. There is more dust
in the environment. It must be cleaned once a week or even every
day. Pull down the front plate. Clean the filter, you can tap the filter
when cleaning, or use a vacuum cleaner to remove the dust
on the filter. Or put the mesh into warm water and add neutral
detergent to clean. Rinse well, let dry and pack. Do not use fire to
avoid deformation
19