Wesco WS4750.1 Notice Originale page 11

Larger angles will cut ridges into the workpiece and affect the
surface finish. Move the angle grinder across and back and
forth over the workpiece.
4. When using a cutting disc never change the cutting angle
otherwise you will stall the disc and angle grinder motor or
break the disc. When cutting, only cut in the opposite direction
to the disc rotation. If you cut in the same direction as the disc
rotation the disc may push itself out of the cut slot.
5. When cutting very hard material best results can be achieved
with a diamond disc.
6. When using a diamond disc it will become very hot. If this
happens you will see a full ring of sparks around the rotating
disc. Stop cutting and allow to cool at no load speed for 2-3
minutes.
7. Always ensure the workpiece is firmly held or clamped to
prevent movement.
MAINTENANCE
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working controls free of
dust. Occasionally you may see sparks through the ventilation slots.
This is normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with
household waste. Please recycle where facilities exist.
Check with your local authorities or retailer for recycling
advice.
TROUBLESHOOTING
Although your new angle grinder is really very simple to operate, if
you do experience problems, please check the following:
1. If your grinder will not operate check the power at the main
plug.
2. If your grinder wheel wobbles or vibrates, check that outer
flange is tight; check that the wheel is correctly located on
the flange plate.
3. If there is any evidence that the wheel is damaged do not
use as the damaged wheel may disintegrate, remove it and
replace with a new wheel. Dispose of old wheels sensibly.
4. If working on aluminum or a similar soft alloy, the wheel will
soon become clogged and will not grind effectively.
5. If a fault cannot be rectified, return the tool to an authorized
dealer or its service agent for repair.
EN
PLUG REPLACEMENT (ONLY FOR
REWIRABLE PLUG OF UK & IRELAND)
If you need to replace the fitted plug then follow the instructions
below.
IMPORTANT
The wires in the mains lead are colored in accordance with the
following code:
Blue = Neutral
Brown = Live
As the colors of the wires in the mains lead of this appliance may not
correspond with the colored markings identifying the terminals in
your plug, proceed as follows. The wire which is colored blue must be
connected to the terminal which is marked with N. The wire which is
colored brown must be connected to the terminal which is marked
with L.
Warning!
Never connect live or neutral wires to the earth terminal of the plug.
Only fit an approved BS1363/A plug and the correct rated fuse.
Note: If a moulded plug is fitted and has to be removed take great
care in disposing of the plug and severed cable, it must be destroyed
to prevent engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
clamped
Fuse
Brown L(live)
Cable grip
11