Publicité
pottery barn kids – PBteen – Pottery Barn – west elm – Williams Sonoma – Williams Sonoma Home – Rejuvenation – Mark and Graham
20-Dec-2022
To Make the Wire Connections:
Gently pull existing wire down from the ceiling junction box and allow wires to hang. The HOT or LIVE wire is
1.
usually black. The NEUTRAL wire is usually white. Check to see if there is a ground wire that is usually green or
green with a yellow stripe or exposed copper metal wire. If need, use a pair of wire strippers to remove about
1/2 inch of insulation from each wire.
Carefully inspect the fixtures wires. The NEUTRAL FIXTURE WIRE has FINE LONGITUDINAL RIDGES
2.
running along its length. The HOT FIXTURE WIRE is SMOOTH and the BARE COPPER WIRE is the
GROUND WIRE. If you have any doubt and cannot identify the power-supply wires with confidence, then we
recommend that you ask an electrician and that you not continue with the installation.
3.
With the help of another person to hold the weight of the fixture, attach the fixture wires to the junction box
wires as shown in the illustrations.
NOTE: IT IS IMPERATIVE THAT THE JUNCTION BOX IN YOUR HOME BE PROPERLY GROUNDED! DO NOT
REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE COMPROMISED.
4. Check the wiring connections and if all looks good, gently tuck the wire connections neatly into the ceiling
junction box.
Williams-Sonoma Inc.
Connect the GROUND FIXTURE WIRE to the GROUND
J-BOX WIRE (usually green insulation or bare wire)
using the Plastic Wire Nut Connector (A) and wrap the
connection with electrical tape. Be sure that no wire
pstrands are exposed.
If the junction box DOES NOT have a GROUND WIRE,
wrap the fixture's bare ground wire around the Green
Ground Screw (B) and insert the screw into the Mounting
Plate (E), marked as "GND", and tighten screw to secure
the wire.
Connect the NEUTRAL FIXTURE WIRE to the NEUTRAL J-
BOX WIRE (usually white insulation)first and then connect
the HOT FIXTURE WIRE to the HOT J-BOX WIRE (usually
black insulation)using the Plastic Wire Nut Connectors (A).
Wrap these connections with electrical tape. Be sure that
no wire strands are exposed.
Assembly
Instructions
Instructions d'assemblage
nstrucciones de Ensamblaje
10/12
USA – A – HODSS
Publicité
