Publicité
ENGLISH
3 Hand without Date / 3 Hand with Date
(Automatic STP1-11, STP3-13)
Setting the time
1 . Unscrew (if necessary) and pull out crown to position 1 .
2 . Pull crown out to position III (the watch stops) .
3 . Turn crown until you reach the correct time .
4 . Push crown back to position I, and screw back (if necessary) .
Setting the date
1 . Pull crown out to position II (the watch continues to run) .
2 . Turn crown until yesterday's date appears .
3 . Pull crown out to position III (the watch stops) .
All manuals and user guides at all-guides.com
2
4 . Turn crown until correct date appears .
5 . Continue to turn crown until correct time appears .
6 . Push crown back to position I .
Do not change the date between the hours of 10pm and 2am. This is the time
when the movement is in position to carry out the automatic date change,
and any interference may cause damage to the movement.
Automatic Winding Movement
A timepiece fitted with an automatic winding movement obtains the power to
wind itself by the movement of your wrist . It is important that your timepiece
is adjusted to match the size of your wrist . A loose fit may result in a loss in
capacity of the timepiece to wind itself . When fully wound, your timepiece
has a power-reserve of approximately 42 hours . If the timepiece has not been
worn for over 42 hours it is advised that it be manually wound to ensure
necessary power-reserve .
3
Publicité
