Publicité
A
DESCRIPTION
D41S V4 9C1
>PP-(T20+S27)<
C
E
Thank you for purchasing a Genuine Mazda Accessory.
Before removal and installation, Please thoroughly read these instructions.
For your safety, please read the contents of this booklet to properly install and use the rear garnish.
Keep these instructions with your vehicle records for future reference.
The rear garnish must always be installed as a set together with the front garnish
DFR5 V4 9A0) and the side sill garnishes (DADK V4 9B0/DFR5 V4 9B0).
So as not to omit installing any required accessories, install in the order of the front garnish (DADK
V4 9A0/DFR5 V4 9A0), the rear garnish (DADK V4 9C0/DFR5 V4 9C0) and then the side sill gar-
nishes (DADK V4 9B0/DFR5 V4 9B0).
•
There are several
or removing the rear garnish. Always read and follow the instructions in order to prevent injuries, accidents, and
possible damage to the vehicle.
WARNING
CAUTION
• For areas indicating the tightening torque in this instruction manual, tighten to the specifi ed torque by using a
torque wrench. For areas in which the tightening torque is indicated inside parentheses ( ), the tightening torque is
indicated as a reference value, however tightening using a torque wrench is not necessary.
• Do not modify the rear garnish.
• Do not install the rear garnish in any way other than described in the following instructions.
• If in doubt, please contact your Mazda dealer to install the accessory in order to prevent errors in installation.
• If you have any questions about the use of the accessory, ask your Mazda dealer for proper advice before using it.
• Mazda and its suppliers are not responsible for injuries, accidents, and damage to persons and property that arise
from the failure of the dealer or installer to follow these instructions.
• To ensure safety and reliability of the work, installation, removal and disposal work must be carried out by an
Authorized Mazda Dealership.
• Be careful not to lose removed parts, and be sure that they are kept free of dirt, scratches, or damage.
NOTE
To the dealer
• Please turn over these instructions to the customer after installation.
To the customer
• Keep these instructions after installation. The instructions may be necessary for installing
other optional parts or removal of this accessory.
• Should the vehicle or this accessory be resold, Always transfer these instructions to the
next owner.
MAZDA MOTOR CORPORATION
3-1 Shinchi, Fuchu-cho, Aki-gun, Hiroshima 730-8670
G
Separate Purchase
Front garnish
(DFR5 V4 9A0/DADK V4 9A0)
I
Separate Purchase
Rear under spoiler accessories
[L=20]
GENUINE REAR GARNISH
INSTALLATION INSTRUCTIONS
(DADK V4 9A0/
WARNING
WARNING and
CAUTION sections in this booklet concerning safety when installing
: Indicates a situation in which serious injury or death could result if the warning is ignored.
: Indicates a situation in which bodily injury or damage to the vehicle could result if the
caution is ignored.
202002
(D41S V4 93E)
B
1x
D
MAZDA CX-30
GARNISH-REAR
/ Part No.
D41S V49C0
Cut-off line
DFR5 V49C0
DADK V49C0
Cut-off line
Cut-off line
4x
F
1x
H
Separate Purchase
Side sill garnish
(DFR5 V4 9B0/DADK V4 9B0)
1x
J
Separate Purchase
2x
Sheet 4 of 15
A-LH
Align template with edge
Cut-off line
A-RH
Align template with edge
Cut-off line
C-LH
C-RH
PL
PL
Align template with PL
Align template with PL
Align template with edge
Align template with edge
CAUTION Check above scale to ensure it is 1:1. Adjust on photo copier if it is not scale.
Kraftfahrt-Bundesamt
DE-24932 Flensburg
Allgemeine Betriebserlaubnis (ABE)
National Type Approval
ausgestellt von:
Kraftfahrt-Bundesamt (KBA)
nach § 22 in Verbindung mit § 20 Straßenverkehrs -Zulassungs -Ordnung (StVZO)
für einen Typ des folgenden Genehmigungsobjektes
Heckschürze
issued by:
Kraftfahrt-Bundesamt (KBA)
according to § 22 and 20 Straßenverkehrs -Zulassungs -Ordnung (StVZO) for a type
of the following approval object
rear skirt
Genehmigungsnummer : 31726
Erweiterung: --
Approval number:
Extension:
1.
Genehmigungsinhaber:
Holder of the approval:
Mazda Motor Europe GmbH
DE-51371 Leverkusen
2.
Gegebenenfalls Name und Anschrift des Bevollmächtigten :
If applicable, name and address of representative:
Entfällt
Not applicable
3.
Typbezeichnung:
Type:
DFR5-V4-9C0
3M Promoter 4298
[C830-V3-149 (EU only)]
4x
Cut-off line
1x
Scale (100mm)
1x
1x
1x
Publicité
