AIRFORCE PRIMA DOMINO 30 Prescriptions De Montage Et Mode D'emploi page 36

Les langues disponibles

FUNZIONAMENTO

OPERATION

THERMAL PROTECTION

The induction hob is equipped with safety devices to protect the electronic system and each cook-

ing zone from overheating.

• When the touch controls exceed a preset temperature, the heating elements automatically

switch off (the display shows 'F' and 'c' alternating - error message 'Fc'). In this case, allow the hob

to cool down before using it again.

OVERHEATING OF THE COOKING ZONE

• Cooking zone off: the cooking zone display shows "H" and "C" alternating or only "C" flashing.

• Cooking zone on: the cooking zone display shows (alternating) the set power level and 'C' .

The cooking zone is not powered.

Let the cooking zone cool down before using it again.

OVERHEATING OF THE INDUCTION GENERATOR

• Cooking zone off: the cooking zone display shows "H" and

'c' alternating or only 'c' flashing.

• Cooking zone on: the cooking zone display shows (alternating) the set power level and "c".

The cooking zone is not powered.

Let the cooking zone cool down before using it again.

ERROR CODES IN DISPLAYS

If an error message appears in the display(s) (the display(s) show(s)

"F " alternating with another character - e.g. "F" and "A", "F" and "0", .....) :

1. Switch off the hob and disconnect it from the mains.

2. Reconnect the hob and switch it on.

3. Wait about two minutes and if the problem is no longer displayed, the hob can be used.

4. If the problem does not disappear, repeat steps 1 to 3.

5. If the problem persists, disconnect the hob from the mains and contact the Authorised Service

Centre.

Important: In case of an error message, "F" and "C" or "F" and

"c", see notes above.