Publicité
Les langues disponibles
Les langues disponibles
Safety information
• If a brush or a brush cover is not assembled
correctly, scratches may occur on the floor,
or product malfunction may occur.
• Use both hands to carry the product.
• Do not place the Clean Station in a place
where people pass by frequently, in
entrance way or narrow passage.
- People may trip over it and be injured, or
product damage may occur.
• Do not push the Clean Station.
In use
WARNING
• If any abnormal sounds, smells or smoke
come from the Jet Bot, immediately shut
off the power switch of the Jet Bot and
contact a service center.
CAUTION
• Using the Jet Bot on a thick carpet may
damage both the Jet Bot and the carpet.
- The Jet Bot cannot pass over a carpet
with fiber longer than 2 cm.
• Do not use the Jet Bot on tables or other
high surfaces.
- There is a risk of damage if it falls.
• The Jet Bot may bump into chairs or desk
legs, therefore move them away for faster
and efficient cleaning.
• When the Jet Bot is operating, do not lift it
up or carry it to another area.
• Do not hold by Driving Wheels of the Jet
Bot when carrying it to another area.
• Do not put any objects on top of the Jet Bot
since it may cause malfunction of the LiDAR
sensor or the Jet Bot.
• Remove any large papers or plastic bags
immediately when using the Jet Bot since
they may block the intake.
• Do not lie down around the Jet Bot that is
running.
- Your hair may be caught in the brush,
resulting in physical injury.
• Do not allow children to play with the Jet
Bot.
• Make sure hair, fingers, clothes do not get
caught in a spin brush or Driving Wheels.
• Do not allow children to sit on the Jet Bot
and do not place an object on the Jet Bot.
• Leave over 3 cm space from the inner
doorstep placed in the entrance. Otherwise,
the robot vacuum can ride on it and go
outside.
Cleaning and maintenance
WARNING
• When the power cord is damaged, contact
a service center to get it replaced by a
certified repairman.
- There is a risk of fire or electric shock.
• Please check with a SAMSUNG Electronics
service center when replacing batteries.
- Using batteries from other products can
cause malfunction.
• Be careful not to put your finger into the
revolving LiDAR sensor. Otherwise, your
finger may get injured.
CAUTION
• Prevent any damage to the Jet Bot by
complying with the following.
- Do not clean the Jet Bot by spraying
water directly onto it or use a volatile
substance such as benzene, thinner, or
alcohol to clean it.
• Do not disassemble or repair the Jet Bot.
This should only be done by a certified
repairman.
• Always keep the Obstacle Sensor Window
and the Cliff Sensor Window clear.
- If foreign matter accumulates, sensors
may malfunction.
• Do not store the Jet Bot in a car.
English 13
Publicité
